18017 Laser LASER: Cannot continue, laser is not ready All The laser is not yet ready for the requested operation. The command can be attempted again once the firmware has signalled that the laser is ready. Click on 'Resume'. If this same message is repeated, wait 30 seconds and click on 'Resume' again. Repeat this action until the Platesetter restarts. You may also watch the message log window for the "Laser is ready" message. Laser is calibrating. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:48 2008 PST